How does Dri-Z-Air™ remove excess moisture from the air?
Dri-Z-Air™ crystals absorb moisture from the air. Excess moisture can cause mold and mildew to form. Using Dri-Z-Air™ will keep this from happening. It’s simple!

How do I use Dri-Z-Air™?
To use Dri-Z-Air™, remove the clip and lift off the upper half of the grill-work compartment.  Open one envelope of crystals and empty it into the bottom half of the grill-work compartment.  Replace the top half of the grill-work and the clip.  Dri-Z-Air™ is ready to use.

Where can I find Dri-Z-Air™ products?
You can find Dri-Z-Air™ products at your local participating store.
Please see the list of Dri-Z-Air™ retailers.
How many Dri-Z-Air™ units do I need?
We recommend one Dri-Z-Air™ unit for every 10’ x 10’ space. For example, use one Dri-Z-Air™ unit in a small bedroom or three Dri-Z-Air™ units in a 25’ motor home. The placement of the units is important. In a 25’ motor home, place a Dri-Z-Air™ unit in the rear, middle and front.

Do I need to dispose of the Dri-Z-Air™ liquid daily?
The Dri-Z-Air™ unit does not have to be emptied until all the crystals have dissolved. The liquid in the bowl will not evaporate, but will continue to collect moisture. We do want to caution not to spill the liquid, since it collects moisture. If you have the Dri-Z-Air™ units where they might get bumped or kicked, please put the unit on a Dri-Z-Air™ tray or in a plastic bowl to catch any spills.

When filling the Dri-Z-Air™ unit with the Dri-Z-Air™ crystals, I noticed some small particles falling to the bottom of the Dri-Z-Air™ unit. Are these going to waste?
No, these are not wasted. They will work the same as the crystals in the basket. Our specifications allow for a percentage of small particles which cannot be avoided.

How do I dispose of the liquid in the Dri-Z-Air™ unit after all the crystals have dissolved?
If you are on a city sewer system, dump the liquid down the toilet. If you are on a septic system, place the collected liquid in a plastic jug and dispose it in your garbage. Do not dump it in your holding tank as the liquid can be corrosive to metal.

How do I clean up the liquid if it spills?
Use only plain cold water. Vacuum up the spill with a wet/dry vacuum, soak the area with water, vacuum, repeat several times. Let the area dry. If it stays dry that is a sign that the spill is cleaned. If it gets damp again, repeat the process.

Why is Dri-Z-Air™ corrosive to metal and leather?
Dri-Z-Air™ is calcium chloride, which is a salt product. When the liquid comes in contact with metal for a prolonged period, the metal will corrode. If it comes in contact with leather, it will dry out and become damaged.

Why do the Dri-Z-Air™ crystals change color?
The color change is caused by dust from the air.

Why do the Dri-Z-Air™ crystals get hard?
The Dri-Z-Air™ crystals are calcium chloride, which is a non-toxic inorganic salt product. As with table salt, when they collect moisture, they harden. Dri-Z-Air™ crystals are like a moisture-absorbing-magnet as it pulls the moisture from the air. When the crystals have grabbed all the moisture they can hold, the liquid will begin filling the bottom of the unit and the crystals will dissolve.

Will Dri-Z-Air™ reduce the humidity to undesirable levels?
No. The Dri-Z-Air™ crystals absorb moisture when the humidity is higher than 50% in the air. If the humidity falls below 50%, the crystals will go into a holding pattern and will begin working again once humidity increases above 50%.

Where does your calcium chloride come from?
Dri-Z-Air™ calcium chloride crystals are made in U.S.A.from high grade materials mined in the U.S.A.

Where can I find your material safety data sheet?
Click on this link for information. Dri-Z-Air™ Safety Data Sheet